Table 19-8 Available Functions for COM PortsRange Communication PortsCOM port 0 COM port 1 COM port 2None The transceiver can communicate with KPG-D1/ D1N.Data The transceiver can remotely be controlled using PC commands.The transceiver can communicate with KPG-D1/ D1N.GPS -Position data can be acquired from the GPS receiver unit.Also, the transceiver can send the received GPS data whenthe transceiver receives the GPS data from anothertransceiver.The transceiver can communicate with KPG-D1/ D1N.Data + GPS Data OutputThe transceiver can remotely be controlled using PC commands.The transceiver will send GPS data by adding STX and ETX when the transceiver receivesGPS data from another transceiver.The transceiver can communicate with KPG-D1/ D1N.Transparent - The port functions as the data communication port for theTransparent data communication using NXDN protocol.Transparent 2 (NXDN) -The port functions as the data communication port for theTransparent data communication using NXDN protocolwhich the communication method is optimized. By usingTransparent 2 (NXDN), data can be sent more efficiently thanusing Transparent.COM port BluetoothVarious functions can be assigned to Bluetooth communication ports.Table 19-9 Available Functions for Bluetooth Communication PortsRange Bluetooth Communication PortNone The transceiver can communicate with KPG-D1/ D1N.Data The transceiver can remotely be controlled using PC commands.The transceiver can communicate with KPG-D1/ D1N.Data + GPS DataOutputThe transceiver can remotely be controlled using PC commands.The transceiver will send GPS data by adding STX and ETX when the transceiver receives GPSdata from another transceiver.The transceiver can communicate with KPG-D1/ D1N.Transparent The port functions as the data communication port for the Transparent data communication usingNXDN protocol.Transparent 2 (NXDN)The port functions as the data communication port for the Transparent data communication usingNXDN protocol which the communication method is optimized.By using Transparent 2 (NXDN), data can be sent more efficiently than using Transparent.Note0 For Mobile, the PC command such as J Command which notifies a user that the transceiver status has been changedcannot be sent from the COM port 0.0 If “Display Unit” is configured in Bluetooth Interface Selection, “Transparent” and “Transparent 2 (NXDN)” cannot beconfigured in COM port Bluetooth.0 Refer to “Communication Ports” in “Multi RF Deck/ Multi Control Head” for the configuration of COM port in a Multi RFDeck/ Multi Control Head structure for Mobile.0 To use COM port Bluetooth, a connection by Serial Port Profile of Bluetooth is required. Refer to “About Serial PortProfile (SPP Connection/ SPP Disconnection)” for the connection by Serial Port Profile.0 The transceiver is equipped with a communication port on the connection of the internal PC board in the transceiver.Refer to the service manual for details.19 CONFIGURATION FOR EACH FUNCTION19.4 Available Functions for COM PortCommon FUNC (K, F)/Ver 2.20 421CONTENTS INDEX
