Caller ID StackCaller ID Stack is the function to store IDs of callers in the stack memory.The transceiver can store a maximum of 250 Caller IDs.By selecting a Caller ID and pressing the PTT switch while in Stack Mode, the transceiver can respond to the Caller ID.When the transceiver receives a call, the “ ” icon blinks to notify that the ID is being saved. If the transceiver enters StackMode, a user can check the stored IDs.About the Caller ID Stack configurationThe transceiver behaves as follows according to the configuration in Caller ID Stack:Table 3-10 Caller ID StackConfiguration DescriptionNone The Caller ID is not stored even if a call is received.Individual Call Only the Caller ID of an Individual Call or Paging Call is stored.Any Call The Caller IDs of all calls are stored. However, the Caller IDs of Unaddressed Calls and Broadcast GroupCalls are not stored in a DMR Conventional system.Note0 The transceiver stores in combination a maximum of 250 Caller IDs and Status Messages in the stack memory. If noStatus Message is stored, the transceiver stores up to 250 Caller IDs.0 The storage method varies depending on the configuration in Old Message Overwrite.Configuration using KPG-D1/ D1N0 Configuring Caller ID Stack (P25) to be enabled of disabled ( Transceiver Settings > P25 > P25 Information >General > Stack)0 Configuring Caller ID Stack (NXDN) ( Transceiver Settings > NXDN > NXDN Information > General > Stack)0 Configuring Caller ID Stack (FleetSync) ( Transceiver Settings > FleetSync > FleetSync Information > General> Stack)0 Configuring Caller ID Stack (MDC-1200) ( Transceiver Settings > MDC-1200 > MDC-1200 Information > General> Stack)0 Configuring Caller ID Stack (DMR) ( Transceiver Settings > DMR > DMR Information > General > Stack)3 BASIC OPERATIONS3.7 Viewing the Receive History (Stack)Common FUNC (K, F)/Ver 2.20 56CONTENTS INDEX
