Function Name DescriptionAvailableCommunicationSystems*1Call InterruptionA Call Interruption request message is sent.SeeDMR FUNC Terminating Voice Communications by a Transceiver Other Thanthe Transmitting Transceiver (Call Interruption)DMR ConventionalCall ResponsePressing the Call Response key when receiving an Individual Call causes thetransceiver to respond.See0 P25 FUNC Making an Individual Call0 NXDN FUNC Initiating an Individual Call After Ensuring That the TargetParty Is Available for Communications (Individual Call AcknowledgeRequest)0 NXDN FUNC Initiating an Individual Call After Ensuring That the TargetParty Is Available for Communications (Message Trunked (Enhanced))P25 TrunkingNXDN ConventionalNXDN TrunkingChannel Down Decreases the channel number in steps of 1. ALLChannel Down(Continuous)Pressing and holding the Channel Down key causes the channel number tobe decreased in steps of 1 every 200 ms.NoteChannel Down (Continuous) can be configured only in Hold for the ChannelDown key, and the configuration cannot be changed.ALLChannel EntryDirectly specify the channel number by pressing a key(s) on the keypad.SeeChanging the Channel by Specifying the Number (Channel Entry)ALLChannelInformationChanges the display of the transceiver in order of the channel name, Zone-channel number, frequency, QT/ DQT, and RAN code. ALLChannel RecallPressing the Channel Recall key while scanning causes Channel Recall tobe toggled between enabled and disabled. If Channel Recall is enabled, thetransceiver migrates to the channel on which a signal was last received.See0 NXDN FUNC SCAN0 P25 FUNC ### Error: NO TOC title. ###0 DMR FUNC SCANALLChannel Up Increases the channel number in steps of 1. ALLChannel Up(Continuous)Pressing and holding the Channel Up key causes the channel number to beincreased in steps of 1 every 200 ms.NoteChannel Down (Continuous) can be configured only in Hold for the ChannelUp key, and the configuration cannot be changed.ALLClear Aborts the current mode, disconnects communication, or cancels datatransmission.P25 TrunkingNXDN ConventionalNXDN TrunkingDMR ConventionalClockThe current time appears.SeeDisplaying the Current TimeALLClock AdjustmentThe current time can be adjusted.SeeAdjusting the TimeALLCW MessageSends the CW Message configured for the transceiver.SeeNXDN FUNC Communicating using a CW MessageNXDN Conventional19 CONFIGURATION FOR EACH FUNCTION19.1 Available Functions for the PF KeysCommon FUNC (K, F)/Ver 2.20 395CONTENTS INDEX
