11.2 D-sub 25-pin ConnectorSupported Models: MobileFor Mobile, the transceiver is equipped with function ports (AUX Input/ AUX Output) that can be programmed for use withthe D-sub 25-pin connector located on the rear panel of the transceiver.Available Functions for AUX Input PortsThis section describes each function that can be assigned to AUX Input ports.Depending on a function assigned to an AUX Input port, the function immediately functions if the AUX Input port is activewhen the transceiver is turned ON. In addition, depending on the function assigned to an AUX Input port, the function doesnot function when the transceiver is in the Radio Inhibit state. Refer to the following table for how the function functionsdepending on the transceiver status.Table 11-3 Behavior of Each Function Depending on the Transceiver StatusFunctionTransceiver StatusWhen the transceiveris turned ONWhile the transceiveris in the Stun stateWhile the transceiver isin the Radio Inhibit stateExternal PTT (Voice) No No NoExternal PTT (Data) No No NoData PTT No No NoExternal PTT (PA) No No NoChannel Select A to Channel Select D Yes *1 *1DTC Yes *1 *1Speaker Mute Yes Yes *1Mic Mute Yes Yes *1External Monitor Yes Yes *1External Hook Yes Yes *1External Speaker Yes Yes *1Emergency Yes No NoAUX Input Status Message 1 to AUX InputStatus Message 3 No No NoScan Yes *1 *1Call 1 to Call 6 No No NoLight Sense Yes Yes *1Zeroize Yes No NoScrambler/ Encryption Yes *1 *1*1 The function functions when the Stun or Radio Inhibit state is reset.Yes: functions, No: does not functionConfiguration using KPG-D1/ D1NAssigning functions to the AUX Input port ( Transceiver Settings > Extended Function > AUX)11 EXTERNAL PORTS11.2 D-sub 25-pin ConnectorCommon FUNC (K, F)/Ver 2.20 211CONTENTS INDEX