0 If Auto Recording does not start because a file having the same file name exists“SD Card Error” appears on the display for 1 sec.Menu Zone +IndividualTRUCK 82412 : 34 AMSD Card ErrorIf the audio is recorded to a microSD card, Auto Recording does not start if a file having the same file name exists in theAR folder.Note0 If one of the following occurs during the recording, the timer for Maximum Recording Length stops and the recordingends:0 The Gap timer elapses (the recording continues for 3 sec from when the transmission or reception completes. Thisduration of time is called the Gap timer.)0 The channel or site is changed0 Scanning starts or stops0 The transceiver enters Emergency Mode0 The data transmission starts0 The PTT switch is pressed while Public Address is enabled (Mobile only)0 The PTT switch is pressed while Intercom is enabled (only for a Dual Control Head structure of Mobile)0 The Clear key is pressed and the communication ends0 The DTMF code and “#” code are received, and the matching state of Optional Signaling is reset0 While Priority Scan or Priority Monitor Scan is activated, the transceiver behaves as follows:0 Regardless of the configuration in Recording Type, the muted sound is recorded while Lookback is activated.0 If “All TX/RX Audio” is configured in Recording Type, and if a signal of a Priority Channel is received while the receivedaudio of a Normal Channel (which is not the Priority Channel) is recorded, the recording continues and the receivedaudio of the Priority Channel is recorded.0 If “Individual Call” is configured in Recording Type, and if a signal of a Priority Channel is received while the receivedaudio of a Normal Channel is recorded, the recording of the Normal Channel ends, and then recording of the PriorityChannel starts.0 During transmission, the audio is recorded via the Mic Line or MI2 Line.0 The recorded audio can be played back or deleted in Playback Mode. (Refer to Playing Back the Recorded Audio(Playback).)0 When transmitting data, Auto Recording does not start.0 Although a Transmit Tone is recorded, a Control Tone and Side Tone are not recorded.0 If “All TX/RX Audio” is configured in Recording Type, the ID information is not stored when Auto Recording is started.0 After the configuration data is written, the configuration values in Internal Memory of Maximum Recording Length beforeand after writing are compared for each RF Deck. If the configurations differ, the audio data recorded in the internalmemory is deleted.0 If the configuration data with Audio/GPS Data Erase (Internal Memory) enabled is written, the audio data recorded inthe internal memory is deleted.0 If Auto Recording is used with other functions such as GPS Data Storage, the beginning may be missing from the audiorecorded by Auto Recording.9 STORING RECORDED AUDIO/ GPS DATA9.2 Recording Received Audio Automatically (Auto Recording)Common FUNC (K, F)/Ver 2.20 162CONTENTS INDEX
