Configuring the FPU Data and Writing the FPU Data to Each RF DeckFPU data that supports Multi RF Deck/ Multi Control Head can be created by using KPG-D1/ D1N having firmware version1.60 or later.For example, this section describes the procedure to create FPU data for Triple RF Deck/ Dual Control Head.The frequency configuration is UHF for RF Deck 2 and 700/ 800 MHz for RF Deck 3. Create FPU data for each RF Deck(frequency).NoteThe procedure to write FPU data for Single RF Deck/ Dual Control Head differs from the procedure to write FPU data forMulti RF Deck/Multi Control Head.1 Make the system in a Single RF Deck/ Single Control Head structure, and write FPU data to each RF Deck.RF Deck 1(N X-5*00)Control Head1 Control Head2KRK-15BRF Deck 2(N X-5*00)KRK-15BRF Deck 3(N X-5*00)KRK-15BKRK-14HBasic Panel(KCH-19)KRK-14HBasic Panel(KCH-19) (KCH-20R)Basic PanelKRK-15BDip SWKRK-14H or KCH-20RDip SWKCT-71KPG-D1/D1NFigure 16-6 Single RF Deck/ Single Control Head2 Create FPU data by using KPG-D1/ D1N.For example, create FPU data for VHF.0 Specify Model Name and enable Multi RF Deck in Product Information.0 Select the Control Head to be connected to RF Deck 1 from Control Head 1.0 Select the Control Head to be connected to RF Deck 2 from Control Head 3.NoteTo write FPU data even when connecting a Featured Panel to Control Head 2, a Basic Panel needs to be connectedto write the FPU data. If Basic Panel is configured for Control Head 1 in the FPU data configuration, the FPU datacannot be written with a Featured Panel connected.16 MULTI RF DECK/ MULTI CONTROL HEAD16.4 Configuring the Initial ConfigurationCommon FUNC (K, F)/Ver 2.20 252CONTENTS INDEX
