06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)40PRINT PARAMETERSPrint speed64-xx ALX 92x DPM PEM ALX 73x (PMA)The print speed (material feed) can be adjusted according to the ribbon andmaterial combination being used in order to optimise the contrast depth andthe density of the print image.x inch/s (mm/s) Setting range: see table (tab. 3); Unit interval: 1 inch/s (5 mm/s)Default setting: 8 inch/s DPM / PEM / ALX 92x / ALX 73x (PMA): Print speed can be set optionallyin Inch/s or mm/s. The unit is selected with SYSTEM PARAMETER > Speed unit.Feed speed64-xx ALX 92x DPM PEM ALX 73x (PMA)Setting:The value for the feed speed should not be set too high for print applicationswith long calculating units (e. g. consecutive numbering). This can help toavoid alternating between abrupt braking to 0 (zero) and acceleration to printspeed. When altering the print speed, the feed speed is equal to the print speed.If a different feed speed is required, this must be set again.x inch/s (mm/s) Setting range: see table (tab. 3); Unit interval: 1 inch/s (5 mm/s)Default setting: 8 inch/s DPM / PEM / ALX 92x / ALX 73x (PMA): Print speed can be set optionallyin Inch/s or mm/s. The unit is selected with SYSTEM PARAMETER > Speed unit.Printer Print speed / feed speed(mm/s) (Inch/s)64-04/05 2-166406 2-1464-08 2-9ALX 924/5, DPM 4/5“, PEM 4/5“,ALX 734/5 (PMA)50-400 2-16ALX 926, DPM 6“, PEM 6“,ALX 736 (PMA)50-300 2-12[3] The setting range of the print/feed speed depends on the printer type.
