06/15 Rev. 10 USER + SERVICE MANUAL /Status Reports64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6271471 Y-OffsetStatus The y-position of a layout element (graphics, text, ...) is beyond the labelmargin. The element is shifted automatically to the first admissible positionat the correct side of the margin.Measure Check the y-positions of the layout elements and change them, ifnecessary. Please read the notes in section Easy-Plug errors .1501-1535 Messages, which can occur in MLI emulation modeNovexx Solution´s MONARCH LANGUAGE INTERPRETER™(MLI™)helps you use a Novexx AP 5.4, 64-xx, ALX 92x, DPM or PEM printerwhich was set up for use with ZIH Corp.´s ZPL II® 1) . If you have anyquestions about using a Novexx printer with these data streams, pleasecontact Service.This section lists the error messages that may appear when using theZPL II® commands interpreted by the Novexx printer´s MONARCHLANGUAGE INTERPRETER™.1501 Unknown MLI CmdError level 1Status An uninterpretable command was encountered.Measure Check, if the printjob was proceeded correctly. If yes, ignore the message,if no, modify the printjob.1502 MLI Hash ErrorError level 1Status General software error.Measure Read chapter General software errors on page 8.1503 Filename Too LongError level 1Status Filename is too long.Measure Rename the file with a shorter name.1) ZPL II is a registered trademark of ZIH Corp. ZIH Corp. and Novexx Solutions are not related inany way, and ZIH Corp. has not licensed or otherwise sponsored Novexx Solution's MONARCHLANGUAGE INTERPRETER™. MONARCH®, MONARCH LANGUAGE INTERPRETER, MLI aretrademarks of Paxar Americas, Inc.
