06/15 Rev. 10 USER + SERVICE MANUAL /Status Reports64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6646300 Out of memoryStatus Not enough free memory available, to load additional print jobs. The jobbuffer is completely filled with print jobs.Measure Delete spooler using the parameter SPECIAL FUNCTION > Delete spooler.6301 Incomplete jobStatus The Easy Plug interpreter failed interpreting a certain print job to the end.The print job has possibly not been terminated by a #Q-command.Measure Check, if the print job is properly terminated with #Q.6310 Centr. TimeoutStatus The Easy Plug command #!Xn triggers a status acknowledgement viacentronics Interface. But the PC dosn´t pick up the supplied data.Measure Check the data line connecting printer and PC.6311 Centr. TimeoutStatus The Easy Plug command #!Xn triggers a status acknowledgement viacentronics Interface. But the PC dosn´t pick up the supplied data.Measure Check the data line connecting printer and PC.8001 Shared MemoryStatus General software error.Measure Switch printer off and then back on again after thirty seconds. Please read the notes in section General software errors .8002 Stream BufferStatus General software error.Measure Switch printer off and then back on again after thirty seconds. Please read the notes in section General software errors .8103 TrueDoc FontStatus Error: font with the number given is not contained in the system.Measure Check font no., if necessary select another font.8104 Speedo allocStatus Fault while initializing the speedo fonts.Measure Load firmware new. Refer to the service manual, topic section "Firmware".8105 Load TrueTypeStatus Damaged font file.Measure Switch printer off and then back on again after thirty seconds. Reload font file, if necessary select another font.
