06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)78Head-sensor dist.(Distance between printline and label sensor)64-xx ALX 92x DPM PEM ALX 73x (PMA) Parameter appears only in production mode or if a value > 0 is set.Printhead-sensor distanceSpecial function for setting non-standard punch sensors. Such sensors canbe applied in special application devices ("Nistan"). The value x is the dis-tance between thermal edge and punch sensor in millimeters.x mm Setting range: 0 to 400 mm A „non standard sensor“ must be installed and connected instead of theregular punch sensor. 0 = disabled (the regular punch sensor is used).Ribbon autoecon.64-xx DPM PEM ALX 92xRibbon automatic economy mode („ribbon saving“)Generally can be chosen between thermal transfer printing and thermal directprinting. It is necessary to select the type of printing in order to be able toswitch over the ribbon end detection.Switching on the Ribbon automatic economy mode in thermal transfer modeinterrupts the ribbon feed between print periods. This saves ribbon, particu-larly with long labels with a minimum print area. The additional feature in tur-bo mode is that a higher feed speed is used between the print periods. Thefeed speed is set in PRINT PARAMETERS > Feed speed.With the setting „Thermal/headlift“ activated in thermal direct mode, the print-head is lifted between print periods. This reduces printhead abrasion. The settings „On“, „Thermal/headlift“ and „On Turbo“ should only beactivated with unprinted areas from at least approx. 10 mm in length.Thermal/headlift Thermal direct printing with printhead liftingThermal printing Thermal direct printing (Ribbon-end-LS switched off)On Thermal transfer printing with ribbon automatic economy mode onOff Thermal transfer printing with ribbon automatic economy mode offOn Turbo Thermal transfer printing with turbo ribbon automatic economy mode on
