06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)119Delimiter Char64-xx ALX 92x DPM PEM ALX 73x (PMA)Used as a parameter place marker in MLI format instructions.xxH Default: xx = 2C (0x2C = „Comma“)Label Top64-xx ALX 92x DPM PEM ALX 73x (PMA)Label top offset (y-offet) in dots. Equals the parameter PRINT PARAMETERS >Y-Printadjust, which will be ignored, when MLI printjobs are printed.xxx Dots Setting range: -240 - +240; Default: 0; Step width: 1Left Position64-xx ALX 92x DPM PEM ALX 73x (PMA)Left position offset (x-offset) in dots. Equals the parameter PRINT PARAMETERS >X-Printadjust, which will be ignored, when MLI printjobs are printed.xxx Dots Setting range: -9999 - +9999; Default: 0; Step width: 1Manual Calibrate64-xx ALX 92x DPM PEM ALX 73x (PMA)For endless material, the label length information is sent in the printjob. Forpunched material, the label length has to be detected by activating this func-tion.YES Label length calculation for punched material. Activate this function, if label material has changed. Calibration should be done after changing material, when there are noprintjobs loaded in the printer. Shortcut (in offline mode): press the feed + prog buttons simultaneouslyto activate the calibration.Resolution64-xx ALX 92x DPM PEM ALX 73x (PMA)Print resolution in dpi. A 200 dpi graphic printjob can be printed with a 300 dpiprinthead.xxx DPI Setting range: 200/300 dpi; Default: 300 dpi;
