06/15 Rev. 10 USER + SERVICE MANUAL /Status Reports64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.629Status Parameters to a barcode command is wrong or does not conform withspecs.Measure Modify the bar code command.1512 Code128 Mode ErrError level 1Status Code128 barcode command specifying mode type other than 'AUTO'.Measure Modify the bar code command.1513 Wrong ModeError level 2Status Coda block barcode command specifying mode type other than 'F'.Measure Modify the bar code command.1514 ^BX Parm Err.Error level 2Status Data Matrix bar code command specified an escape sequence character.This is not supported in this printer.Measure Modify the bar code command.1515 Conv to ECC200Error level 1Status Data Matrix barcode command specified non ECC200 level. Program isattempting to convert to ECC200.Measure Modify the bar code command.1516 Bad Drive: xError level 2Status The drive selected is not a valid drive. (We support only 'R' and 'B').Measure Select a valid drive.1517 Mask String: xError level 2Status The mask string used in ^SF command is not supported.Measure Modify the print job.1518 Bad Format: xError level 2Status The graphic format selected is not supported by Avery ZPL Emulation(Compressed binary and PNG format).Measure Convert graphic into a supported format.
