06/15 Rev. 6.01-01 USER MANUAL Einrichten64-xx – 64-xx dispenser17Settings at 64-xx dispensersDispenser typesThe 64-xx is available as „Dispenser M“ or „Dispenser A“ (see tab. 2).Basic settingsThe following table shows a basic setting for those parameters which aremost important for dispenser operation (see tab. 3). The setting can beapplied to both, type M and type A, with the purpose of using afootswitch. It is not possible to connect two foot switches to the printer (USI andSingle Start) and use them simultaneously. Advice on setting parameters can be found in topic section Info printoutsand parameters. Information about operation with start signal can be found in topic sectionAdvanced Applications, chapter „Printing with start signal“.Type Property Operating mode64-xx Dispenser M• Short dispensing edge withlabel sensor• Connector for start/stopsignal (e. g. for footswitch)Printing/dispensing is triggered manually(single start), e. g. by a footswitch. Thedispensed labels are taken off by hand.Alternatively: Printing/dispensing is trigge-red by the label sensor, if a dispensed la-bel is taken off.64-xx Dispenser A• Long dispensing edgewithout label sensor• Connector for start/stopsignal (e. g. for footswitch)Printing/dispensing is triggered manually(single start), e. g. by a footswitch. Thedispensed labels are taken off by hand.Alternatively: The dispensed label is takenover by an applicator.[Tab. 2] Different configuration of „Dispenser M“ and „Dispenser A“.Submenu Parameter SettingSYSTEM PARAMETERSPeriph. device DispenserExternal signal SinglestartStart print mode Pulse risingDISPENSER PARADispense Mode Real 1:1 ModeDispensposition 0 mmDispensing mode fastApplication mode Immediate ModeStart source Foot switchDispensing edge shortTransport mode Dispenser motor[Tab. 3] Basic setting of the parameters most important for dispenser operation - validfor both dispenser versions.
