06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)132Sensor adjust64-xx ALX 92x DPM PEM ALX 73x (PMA) Parameter only appears in production mode. For detailed instructions sensor adjustment, please refer to the servicemanual, topic section "Service Electronics", paragraph "Settings".Sensor test64-xx ALX 92x DPM PEM ALX 73x (PMA) The description of the sensor test can be found in the printer service manual,topic section „Service Electronics“, chapter Sensor test .The values displayed are for checking the sensors (sensor check) and canby adjusted by service personnel.Cutter test64-xxMakes it possible to test the cutter function without having to set the para-meter SYSTEM PARAMETER > Periph. device to „cutter“.Press Cut Key Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.Matend tolerance64-xx ALX 92x DPM PEM ALX 73x (PMA)Material end toleranceThis is relevant for label stock with very long punches. To avoid those punch-es being recognized as material end by mistake, can here the distance beset, after which the gap over the light sensor is interpreted as material end. By choosing a very high material end tolerance, you loose the protectionof the print roller against being printed on!xxx mm Setting range: 20-300 mm; Default setting: 35 mmFeedadjust label64-xx ALX 92x DPM PEM ALX 73x (PMA)Prints a scale, which enables to calculate the feed adjust value (see nextparameter).For application instructions, refer to the Service Manual, topic section„Electronics Gen. 3“, chapter Adjusting the imprint position .
