06/15 Rev. 10 USER + SERVICE MANUAL /Status Reports64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.640Measure 21. Press the Cut button to deactivate the acoustic signal.2. Press the Feed button in order to acknowledge the status report.Display: OFFLINE x JOBS3. Insert a new ribbon.4. Press the Online button: processing of the job continues, gap LS isreinitialised.5009 USI start errorStatus This status message can only be triggered with activated parameterDP INTERFACE > Start error stop. It occurs, if another start signal is given whileprinting a label.Measure Acknowledge by pressing the Online button. Press the Feed buttonafterwards to proceed with the print job.5012 Delete H8 loaderStatus Error while loading the H8 firmware: the old firmware on the machine couldnot be deleted.Measure Acknowledge by pressing the Online button. Retry loading the firmware. If the error occurs repeatedly, the bootloader must be loaded newly.5013 Prog H8 loaderStatus Error while loading the H8 firmware: the new firmware could not be written.Measure Acknowledge by pressing the Online button. Retry loading the firmware. If the error occurs repeatedly, the bootloader must be loaded newly.5014 PowerMeasure Acknowledge by pressing the Online button.
