06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)115Material signal64-xx ALX 92x DPM PEM ALX 73x (PMA) Only with USI board.Concerns the output signal WARNING at the USI, which indicates the closeshortness of ribbon or material.On High, if the diameter of the material roll falls below a certain value. The limitdiameter is set by positioning the outer diameter (OD) sensor. Requirement: "OD sensor material" is installed.Off No material end warning.Mat. signal stop64-xx ALX 92x DPM PEM ALX 73x (PMA) Only with USI board.Defines the reaction of the printer on a material low signal coming from theOD-sensor. See DP INTERFACE > Material signalOff (Default) The output signal WARNING at the USI is activated (precondition:DP INTERFACE > Material signal is set to „enabled“). The printing will be continued.On After a material low warning occured, the printer finishes printing the currentlabel and stops afterwards. The display shows:After acknowledging the message, the printing can be continued.Feed input64-xx ALX 92x DPM PEM ALX 73x (PMA) Only with USI board.Concerns the output signal FEED at the USI.Standard (Default setting) Feed of blank labels as long as signal is "low".Precondition: Off-line mode or printing stopped in on-line mode.JP5 A signal different from the standard FEED can be used. Precondition: an ap-propriate firmware change (NISTAN).Print Status: 5123USI Material low
