06/15 Rev. 04 USER MANUAL Advanced ApplicationsAP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x7Settings in the parameter menu Further settings for 64-xx Dispenser see user manual 64-xx, topic section „Setup“,chapter Settings at 64-xx dispensers on page 17. Settings for application of ALX 92x with applicator see service manual ALX 92x,topic section „Applicator Interface“, chapterSelecting an applicator type on page 5.Setting Interface Printer Parameter ValueAccept start si-gnals -- All SYSTEM PARAMETER > Exter-nal signal SinglestartSignal sourceSinglestartinput64-xx -- a --64-xx Dispenser,AP 5.4 Dispenser,AP 5.6 DispenserDISPENSER PARA > Startsource Foot switchAP 5.4, AP 5.6, AP 7.t -- --Disp. edgelight barrier64-xx Dispenser,AP 5.4Dispenser,AP 5.6 DispenserDISPENSER PARA > Startsource Light barrierUSI 64-xx Dispenser DISPENSER PARA > Startsource USI interface64-xx, ALX 92x, ALX 73x -- --I/O AP 5.4, AP 5.6, AP 7.t -- --AI ALX 92x, ALX 73x -- --Signal flangeSinglestartinput64-xx, AP 5.4, AP 7.t,AP 5.4Gen II, AP 5.6SYSTEM PARAMETER > Startprint mode „Pulse rising“USI 64-xx, ALX 92x DP INTERFACE > Start printmode „Pulse rising“I/O AP 5.4, AP 5.6, AP 7.t I/O BOARD >Start print mode „Pulse rising“AI ALX 92x, ALX 73x APPLICATOR PARA > Startprint mode „Pulse rising“Start delaySinglestartinputAP 5.4Gen II Dispenser,AP 5.6 DispenserDISPENSER PARA > Start Off-setEnter distancebetween startsensor and dis-pensing edgeUSI 64-xx, ALX 92x, ALX 73x DP INTERFACE > Start delayI/O AP 5.4Gen II Dispenser,AP 5.6 DispenserDISPENSER PARA > Start Off-setAI ALX 92x, ALX 73x APPLICATOR PARA > Start de-lay[Tab. 5] Overview on the most important settings for start signal application (Firmware versions 3.52/6.52/7.52).a) „--“ = No setting required.
