06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)126 „Custom defaults“ only appears, if custom settings have already beenstored.Factory defaults The parameters are set to factory defaults.Custom defaults64-xx ALX 92x DPM PEM ALX 73x (PMA) Parameter appears only in production mode.Apply current Stores the current parameter settings as values for the default setup. Thosesettings are restored by calling parameter SPECIAL FUNCTION > Factory settings =„Custom defaults“.Delete Deletes the stored custom default settings. „Delete“ is only visible, if settingshave already been stored.Store Parameters64-xx ALX 92x DPM PEM ALX 73x (PMA)Parameter settings are saved in a text file on memory card (directoryFORMATS\). Considered are also parameters which belong to options,which are not activated.Without adj. par (Default) Parameters, which contain device specific settings, are not saved.(Default file name: SETUP.FOR).Application example: Transfer of printer settings to another printer (devicespecific settings as printhead resistance or sensor settings should not beoverwritten).With adjust para Parameters, which contain device specific settings, are also saved. The rel-evant parameter names are marked with a * in the text file.(Default file name: SETUPALL.FOR).Application example: Service For more information about saving and reading parameter settings read topicsection „Advanced Applications“, chapter „Saving and Transferringparameter settings“.Store Diagnosis64-xx ALX 92x DPM PEM ALX 73x (PMA)Stores the diagnostic data on memory card. The default file name composesas follows:„Diagnose AP 5.4 203 Dpi A429403110613.log“• AP 5.4 203 Dpi: printer type and printhead resolution• A429403110613: serial number of the CPU board; equals the valuedisplayed under SERVICE DATA > CPU board data > Serial number
