06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)107• Start print error• Other errors, which keep the printer from printing During the initialization (powering up) of the printer, the ERROR-signal isinstable!Printererr + Offl In addition to the above mentioned cases avtivate the following events theERROR-signal:• The printer is in offline mode• The printhead pressure lever is open• „I/O board pause“ mode• Stopped mode (the printing was stopped)Error Polarity64-xx ALX 92x DPM PEM ALX 73x (PMA) Only with an I/O board mounted.Switches the polarity of the ERROR signal.Level high activ The output is high when it is active, otherwise low.Level low active The output is low when it is active, otherwise high. (Default)Status output64-xx ALX 92x DPM PEM ALX 73x (PMA) Only with an I/O board mounted.This parameter defines different events, which activate the output signalMACHINE STATUS.Low ribbon warn The signal is activated, if the ribbon roll diameter is less than the limit. See parameter Foil end warning on page 72.Print job ready (Default setting) The signal is activated, if the printer has finished image pro-cessing and is ready to start printing.The signal is not activated, if:• the print job is done,• the print job was stopped,• the printer was switched to offline mode,• the printer is in pause mode.Status polarity64-xx ALX 92x DPM PEM ALX 73x (PMA) Only with an I/O board mounted.Switches the polarity of the MACHINE STATUS signal.Level high activ The output is high when it is active, otherwise low.Level low active (Default setting)The output is low when it is active, otherwise high.
