06/15 Rev. 10 USER + SERVICE MANUAL /Status Reports64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6354100-4106 Message, which can only occur with OLV-Option4100 No OLV dataStatus The OLV found out, that the bar code type and/or the bar code data, whichwas just printed and read, doesn´t match the bar code specified in the printjob. The error may have one of the following causes:• OLV is not connected/switched on• The bar code has not been printed• The bar code has been printed poorly, so that the OLV can not detect it.Measure Check, if the OLV is connected correctly Check the printout quality. If the printout is poor, change the printparameters and/or use a different material/ribbon-combination. Make a dot check. May be, that a dot is defective, which was ought to printan important line of the bar code. If the bar code has not been printed at all: check the print job.4101 OLV limit exceedStatus The read bar code exceeds a user-specified limit. The limits, e.g. contrastor readability, can be set via the parameter menue or via Easy Plugcommand.Measure Check the printout quality. Change the limit. Eventually modify the print parameters or the material/ribbon combination.4103 OLV barcode typeStatus The OLV found out, that the bar code type, which was just printed andread, doesn´t match the bar code specified in the print job.Measure Check the printout.4104 OLV TimeoutStatus General software errorMeasure Please read the notes in section General software errors .
