06/15 Rev. 6.01-01 USER MANUAL Einrichten64-xx – 64-xx dispenser11Material / Ribbon endMaterial endIf the material end has passed the material guiding, the following statusmessage appears:1. Press the opener and pull the remaining material from the front side(display side) out of the print unit.2. Only dispenser version:Open the shutter and pull the remaining backing paper in directionrewinder out of the print unit.3. Take the clip off the rewinder and remove the wound up backing paper. For additional information read section Changing material on page 9.Ribbon endIf the ribbon roll is emptied, that is the ribbon unwinding mandrel stoppedturning, the following status message appaers: Proceed as described in section Inserting ribbon on page 10. The ribbon end detection can be switched off, e.g. for thermal printing. To do so, set the parameter SYSTEM PARAMETERS > Ribbon autoecon. to „ther-mal printing“.Rewinder full Only for dispenser versions!The dispenser rewinder can wind up the backing paper of a roll with210 mm outer diameter and 4“ (102 mm) core inner diameter. If the ma-ximum capacity of the rewinder is reached, the following status messageappears: Proceed as described in section Changing material on page 9. Best clear the rewinder after every printed material roll!Status 5002Material endStatus 5008Ribbon endStatus 5064Rewinder full
