Yamaha TMAX 2020 Service Manual

4-44FRONT BRAKE1. Remove:• Brake pad clip “1”• Brake pad pin “2”• Brake pad spring2. Remove:• Brake pad “1”3. Measure:• Brake pad wear limit “a”Out of specification  Replace the brakepads as a set.4. Remove:• Brake caliper bolt5. Install:• Brake pad• Brake pad springTIPAlways install new brake pads and new brakepad spring as a set.a. Connect a clear plastic hose “1” tightly tothe bleed screw “2”. Put the other end of thehose into an open container.b. Loosen the bleed screw and push the brakecaliper pistons into the brake caliper withyour finger.c. Tighten the bleed screw.d. Install the brake pads and brake pad spring.TIPThe arrow mark “a” on the brake pad springmust point in the direction of disc rotation.6. Install:• Brake pad pin• Brake pad clip• Front brake caliper7. Check:• Brake fluid levelBelow the minimum level mark  Add thespecified brake fluid to the proper level.Refer to “CHECKING THE BRAKE FLUIDLEVEL” on page 3-14.Brake pad lining thickness limit0.5 mm (0.02 in)121 Brake caliper bleed screw6 N·m (0.6 kgf·m, 4.4 lb·ft)Front brake caliper bolt35 N·m (3.5 kgf·m, 26 lb·ft)2 1T R..T R..