Yamaha TMAX 2020 Service Manual

4-79HANDLEBAR4. Install:• Front brake master cylinder assemblyRefer to “INSTALLING THE FRONT BRAKEMASTER CYLINDER” on page 4-47.5. Install:• Handlebar switch holder• Handlebar switch (left)TIPAlign the projection “a” on the handlebar switch(left) with the hole “b” in the handlebar.6. Lubricate:• Rear brake lock cable(to cable end)7. Connect:• Rear brake lock cable(to rear brake lock lever)TIPRotate the lever to the position “a”, and then in-stall the rear brake lock cable.8. Install:• Rear brake master cylinder assemblyRefer to “INSTALLING THE REAR BRAKEMASTER CYLINDER” on page 4-62.9. Install:• Handlebar grip• Grip end “1”a. Apply a thin coat of rubber adhesive ontothe end of the left handlebar.b. Slide the handlebar grip over the end of theleft handlebar.c. Wipe off any excess rubber adhesive with aclean rag.WARNINGEWA13700Do not touch the handlebar grip until the rub-ber adhesive has fully dried.TIPThere should be 1–3 mm (0.04–0.12 in) of clear-ance “a” between the handlebar grip and the gripend.Handlebar switch holder screw3.5 N·m (0.35 kgf·m, 2.6 lb·ft)Handlebar switch screw (left)1.8 N·m (0.18 kgf·m, 1.3 lb·ft)Recommended lubricantYAMAHA GREASE “F”c2ab1T R..abGrip end26 N·m (2.6 kgf·m, 19 lb·ft)aT R..1aG088918