Yamaha TMAX 2020 Service Manual

4-88FRONT FORK14.Measure:• Front fork leg oil level “a”(from the top of the outer tube, with the outertube fully compressed and without the forkspring)Out of specification  Correct.15.Install:• Damper rod locknut• Fork spring• Spacer• Cap bolt(along with the O-ring )WARNINGEWA12850Always use a new O-ring.a. Remove the rod puller and rod puller at-tachment.b. Install the damper rod locknut.c. Install the fork spring and spacer.TIPInstall the spring with the smaller diameter facingup.d. Press down in the spacer with the forkspring compressor “1”.e. Pull up the rod puller and install the rodholder “2” between the damper rod locknut“3” and the spacer “4”.TIPUse the side of the rod holder that is marked “B”.f. Remove the rod puller and the rod puller at-tachment.g. Install the damper rod locknut “3” onto thedamper rod and turn it until it stops.h. Install the cap bolt “5”, and then tighten thedamper rod locknut “3” until it contacts the bolt.i. Hold the cap bolt and tighten the damperrod locknut to specification.j. Remove the rod holder and fork springcompressor.Level (left)114 mm (4.5 in)Level (right)118 mm (4.6 in)aG088930NewFork spring compressor90890-01441Fork spring compressorYM-01441Rod holder90890-01434Damper rod holder double endedYM-01434Damper rod locknut15 N·m (1.5 kgf·m, 11 lb·ft)43 21335T R..