8-106ELECTRICAL COMPONENTSb. Start the engine and let it run at approxi-mately 5000 r/min.c. Measure the rectifier/regulator input volt-age.EAS30573CHECKING THE FUEL SENDER1. Remove:• Fuel pump(from the fuel tank)Refer to “FUEL TANK” on page 7-1.2. Check:• Fuel sender resistanceOut of specification Replace the fuelpump.a. Connect the digital circuit tester () to thefuel pump terminals as shown.b. Move the fuel sender float to empty fueltank position “3” and full fuel tank position“4” level position.c. Measure the fuel sender resistance.3. Install:• Fuel pumpRefer to “FUEL TANK” on page 7-1.EAS31557CHECKING THE FUEL METER/FUEL LEVELWARNING INDICATORThis model is equipped with a self-diagnosisdevice for the fuel level detection circuit.1. Check:• Fuel meter/fuel level warning indicator “1”(Push the ON/start switch.)Fuel meter/fuel level warning indicator comeson for a few seconds, then goes off Fuelmeter/fuel level warning indicator is OK.Fuel meter/fuel level warning indicator doesnot come on Replace the meter assembly.Fuel meter/fuel level warning indicator flash-es eight times, then goes off for 3 seconds ina repeated cycle (malfunction detected in fuelsender) Replace the fuel pump assembly.EAS30577CHECKING THE RADIATOR FAN MOTOR1. Check:• Radiator fan motorFaulty/rough movement Replace.a. Disconnect the radiator fan motor couplerfrom the wire harness.b. Connect the battery (DC 12 V) as shown.Sender unit resistance (full)10.0–14.0 Sender unit resistance (empty)267.0–273.0 Digital circuit tester (CD732)90890-03243Model 88 Multimeter withtachometerYU-A1927• Positive tester probe Green “1”• Negative tester probe Black “2”341