Yamaha TMAX 2020 Service Manual

2-14CABLE ROUTING1. Handlebar switch coupler 1 (left) (black)2. Front brake light switch coupler (black)(for XP560D)3. Rear brake light switch coupler (white)(for XP560D)4. Handlebar switch coupler 2 (right) (white)5. Handlebar switch lead (left/right)/Gripwarmer lead (left/right) (for XP560D)/Frontbrake light switch lead (for XP560D)/Rearbrake light switch lead (for XP560D)6. Wire harness (accelerator position sensorlead)7. Positive battery lead8. Headlight bracket9. Plastic locking tie10. Wire harness11. Handlebar switch coupler (right) (white)12. Handlebar switch coupler (left) (white)13. Electrical components tray14. Grip warmer lead (left/right) (for XP560D)/Front brake light switch lead (for XP560D)/Rear brake light switch lead (for XP560D)A. Arrange the front wheel sensor coupler infront of the wire harness.B. Lead going to meter assemblyC. To front wheel sensorD. Handlebar switch coupler 1 (left) (black),handlebar switch coupler 1 (right), handle-bar switch coupler 2 (right) (white), handle-bar switch coupler 3 (left) (white), rearbrake light switch coupler (white)(for XP560D), front brake light switch cou-pler (black) (for XP560D), handlebar switchcoupler 3 (right) (black) (for XP560E), han-dlebar switch coupler 4 (left) (white)(for XP560E).The order of arrangement of the couplerabove does not matter.E. Refer to “Handlebar (top and left side view)(for XP560D)” or “Handlebar (front view)(for XP560D)”.F. Route the end of the positive battery lead(before the taped section at the bottom) sothat it does not go between the wire har-ness and the headlight bracket.G. Install the clamp to the headlight bracket.H. Fasten the headlight bracket and the whitetape section of the wire harness with theplastic locking tie. The end of the plasticlocking tie should face upward withoutbeing cut.I. Route the handlebar switch lead (left/right)on the inside of the windshield drive unitcable.J. Install the wire harness coupler into thehole on the electrical components tray.K. Pass the plastic locking tie through thehole of the electrical components tray andfasten the white tape section of the lead.The end of the plastic locking tie shouldface downward without being cut.