SETTING ITEMS (ADMIN)- 257 -2134567*2 The target protocols are IPX/SPX, AppleTalk and soon.For details, refer to the TopAccess Guide “Chapter8: [Administration] Tab Page - [Setup] Item List”.Memo• The settable times are described below.- 1 min.- 3 mins.- 5 mins.- 10 mins.- 15 mins.- 20 mins.- 25 mins.- 30 mins.- 40 mins.- 50 mins.- 60 mins.Note• The equipment may not enter the Sleep mode at theset timing depending on its operating status.• The machine is not switched to the Sleep mode in thefollowing cases:- A particular option is installed. (Wireless LANmodule, e-BRIDGE ID Gate)- The IPsec function is enabled.- IEEE 802.1X authentication is enabled.- IPv6 is enabled and the IPv6 address is set otherthan manually.- POP3 client setting is enabled and under any of thefollowing conditions:(1) The scan rate is set to other than 0 minute.(2) A POP3 server address is entered.(3) An account name is entered.- A particular network protocol is enabled. (AppleTalk,IPX/SPX)• Protocol settings for recovering this equipment fromthe Auto Sleep mode are made in the TopAccessadministrator mode. For details, refer to theTopAccess Guide “Chapter 8: [Administration] TabPage”.• By default, the Power Save period is set to 1 min andthe Sleep period is set to 1 min.Setting the calibration display levelYou can set whether this equipment will use the calibrationsetting set by a user or the administrator.The relevant buttons ([CALIBRATION]) will appear under theADMIN menu only or under both theUSER and ADMIN menus according to this setting.Setting the calibrationYou can automatically calibrate the color gradation when theshading and hue are not reproduced accurately in the imagesscanned by this machine.Note• Whether to allow calibration by not only administrators butalso users, is set by DISPLAY LEVEL. P.257 "Setting the calibration display level"• Place LT or A4 paper (recommended paper) in the traybefore starting the calibration. If any other paper is used,calibration may not be performed properly.• If the glass is dirty or any foreign objects are stuck to it,calibration may not be performed properly. Keep the glassclean.• Do not raise the original cover or the Reversing AutomaticDocument Feeder *1, or open the front cover while thecalibration is in progress. If this does happen, calibrationcannot be finished properly.• Interrupt copying is not available during the calibration.• If the color often deviates, call your dealer.*1 The Reversing Automatic Document Feeder is an option depending onthe model.Memo• For instructions on how to display the CALIBRATIONscreen, see the following page: P.229 "Accessing the User Menu"1 Press the button to calibrate.Note• The available buttons differ depending on the model.Item name DescriptionCALIBRATION • USER — Press this button to display[CALIBRATION] in the ADMIN menuas well as the USER menu• ADMIN — Press this button to display[CALIBRATION] in the ADMIN menuItem name DescriptionCOPY Press this button to calibrate forcopy jobs.600 dpi PRINT Press this button to calibrate for 600dpi print jobs.1200 dpi PRINT Press this button to calibrate for1200 dpi print jobs.
