SETTING ITEMS (ADMIN)- 306 -21345674 Specify the following items as required andpress [Next].Memo• When you press [EAP USER NAME], [PASSWORD],or [RETYPE PASSWORD], the on-screen keyboard isdisplayed.For details of the on-screen keyboard, see thefollowing page: P.320 "On-screen keyboard"5 Confirm the settings and press [APPLYNOW].“NETWORK INITIALIZING” is displayed at the lower leftof the screen and this equipment starts initializing thenetwork interface card to apply the changes. Thismessage disappears when the setting is complete.Error messagesThe following error messages may be displayed on the touchpanel.When you selected other than [EAP-TLS]:When you selected [EAP-TLS]:Item name DescriptionEAP USER NAME Press this button to enter the EAPuser name.PASSWORD Press this button to enter theauthentication password.RETYPEPASSWORDPress this button to enter theauthentication password again.Use Usernamefrom CommonName in the UserCertificateTo set the common name in theuser certificate installed in thisequipment as EAP user name,press [ENABLE].Note• If you set this item to [ENABLE],you will not be able to enter[EAP USER NAME].Message Cause[802.1X] Auth Server/Switchcouldn’t be contacted• The RADIUS serverservice is stopped.• Configuration for theRADIUS server is notcorrect.• The IEEE 802.1X switchhas problem.[802.1X] Authentication failed • The username orpassword that the userentered is not correct.• The certificates uploadedare wrong.Certificate verification Failure • A CA certificate is notinstalled in theequipment.• The installed CAcertificate is not valid.• The server certificate isinvalid.
