SETTING ITEMS (ADMIN)- 304 -21345679 Press [YES], and wait until the setting isreflected.Memo• For instructions on how to display the WIRELESS SETTINGscreen, see the following page: P.250 "Accessing the Admin Menu"CHANGE USER PASSWORDWhen the MFP Local Authentication function is used,administrators can change the authentication passwordassigned for each user in case it is forgotten.Note• [CHANGE USER PASSWORD] is available only when theMFP Local Authentication function is enabled. This functioncan be enabled from TopAccess administrator mode. Fordetails, refer to the TopAccess Guide “Chapter 8:[Administration] Tab Page”.Memo• For instructions on how to display the CHANGE USERPASSWORD screen, see the following page: P.250 "Accessing the Admin Menu"1 On the CHANGE USER PASSWORD screen,set a new password and complete thesetting.1) Press [USER NAME] to enter the user name forwhich the password is to be changed.2) Press [NEW PASSWORD] to enter the newpassword.3) Press [RETYPE NEW PASSWORD] to enter thenew password again.4) Press [OK].The password is now changed.Memo• When you press [USER NAME], [NEW PASSWORD]or [RETYPE NEW PASSWORD], the on-screenkeyboard is displayed.For details of the on-screen keyboard, see thefollowing page: P.320 "On-screen keyboard"• The input password appears as asterisks (*) in the[NEW PASSWORD] and [RETYPE NEW PASSWORD]boxes.802.1X SETTINGSYou can make settings for IEEE 802.1X authentication that willapply to wired networks.This equipment supports the following authentication methods:• EAP-MSCHAPv2• EAP-MD5• EAP-TLS• PEAP *1The following protocols are available for innerauthentication:- EAP-MSCHAPv2• EAP-TTLSThe following protocols are available for innerauthentication:- PAP- CHAP- EAP-MSCHAPv2- EAP-MD5*1 PEAP cannot be used for Windows Server 2008.To enable IEEE 802.1X authentication, you must installcertificates in this equipment as required, using TopAccess.The certificates that must be installed are as follows.*1 The CA certificate must be installed in this equipment before thesettings for IEEE 802.1X authentication are performed.*2 The user certificate must be installed in this equipment before thesettings for IEEE 802.1X authentication are performed.Authentication MethodInnerAuthentication MethodCACertificateUserCertificateEAP-MSCHAPv2- - -EAP-MD5 - - -EAP-TLS - Necessary *1 Necessary*2PEAP EAP-MSCHAPv2Necessary *1 -EAP-TTLS PAP Necessary *1 -CHAP Necessary *1 -EAP-MD5 Necessary *1 -EAP-MSCHAPv2Necessary *1 -
