111Functions Used As NeededSet ModeChanging the mode manuallyManually switch to an optimum mode (radio wave type) according to the frequencyband.For more details, see “Changing the Mode Manually” on page 38.Switching between digital and analog modeYou can set digital and analog mode switching and digital transmission mode.Enter the Set mode:1 Press and hold M for over 1 second.2 Turn O to select [2 TX/RX].3 Press H.4 Turn O to select [2 DIGITAL].5 Press H.6 Turn O to select [1 DIGITAL MODE].7 Press H.8 Turn O to select [MODE].9 Press H.10 Turn O to select your desired mode.DIGITAL: Transmit and receive in the digital mode.ANALOG: Transmit and receive in the analog mode.AMS (Automatic Mode Select):Tune to the transmission and reception mode of the remotestation from which a signal is automatically received.11 Press M.12 Turn O to select [DIGI TX].13 Press H.14 Turn O to select a reception mode.DN: Usual digital communication mode. Conversation isinfrequently interrupted even under low power level.VW: (Voice Wide) Full rate high quality sound mode This is the transmission functionto prioritize the sound quality when the communication condition of the remotestation is relatively good.15 Press p to save the setting and exit the Set mode.