62Scanning FunctionUsing the Scanning FunctionTips • Turn O clockwise: Scanning is performed toward higher memory channel numbers.Turn O counterclockwise: Scanning is performed toward lower memory channel numbers.• When a signal is received during scanning, scanning stops for 5 seconds and this frequencyis received.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To stop scanning, press p.• You can select the range for scanning by selecting [5 SCAN] [5 SCAN WIDTH] in the Setmode.Memory Bank Link ScanDuring regular memory bank scanning, only thememory channels assigned to the recalled memorybank are scanned. During memory bank linkscanning, memory channels registered in two ormore previously specified banks can be scanned.1 Press V to enter the Memory mode.2 Press B to enter Recall a memory bank.3 Press F and then B.4 Turn O to select a memory bank.Select a memory bank subject to memory bank link scanning.5 Press V to select a Memory bank link.The memory bank number changes from [B] to [b],indicating that the bank link has been activated6 Repeat steps 4 to 5 to select another memory bank.7 Press B.The memory banks subject to memory bank link scanningare determined.8 Press F and then [2].Scanning (SCAN) is performed toward higher memory channel numbers.Tips • Turn O clockwise.: Scanning is performed toward higher memory channel numbers.Turn O counterclockwise: Scanning is performed toward lower memory channel numbers.• When a signal is received during scanning, scanning stops for 5 seconds and this frequencyis received.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To stop scanning, press p.• You can select the range for scanning by selecting [5 SCAN] [5 SCAN WIDTH] in the Setmode.BANK1 BANK10BANK24The memory bank numberchanges from [B] to [b].