61Scanning FunctionUsing the Scanning FunctionTips To cancel a skip/selected memory channel, select [OFF].When it is canceled, the icon on the LCD disappears.Scanning Only the Selected Memory Channel1 Switch to the Memory mode, and then recall the selectedmemory channel.2 Press F and then 2.Tips • Scanning (SCAN) is performed toward higher memorychannel numbers.• Only the selected memory channel is scanned.• If a signal is received during scanning, a beep is emitted and scanning stops for 5 secondsto receive the current frequency.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To cancel scanning, press p.• You can select the range for scanning by selecting [5 SCAN] [5 SCAN WIDTH] in the Setmode.Scanning a Memory BankOnly the memory channels in the recalled memory bank can be scanned.1 Press V to enter the Memory mode.2 Press B to enter Recall a memory bank.Pressing B each time toggles between [MEMORY NO] and [BANK (No.)].Tips To recall another memory bank, press F and then B.3 Turn O to select a memory bank.Select a memory bank from BANK1 through BANK 24.4 Press B.The selected memory bank is determined.5 Press F and then 2.Scanning (SCAN) is performed toward higher memory channel numbers.Lights when a skip memorychannel is specifiedBlinks when a selectmemory channel is specifiedSkip memorychannel[SKP]Selected memorychannel[SELECT]OOFF