86Communicating with a Specific Remote StationUsing the Tone Squelch FunctionSearching for the Frequency of theTone Squelch Used by the Remote StationThe frequency of the tone squelch used by the remote station can be searched for anddisplayed.Enter the Set mode:1 Press and hold M for over 1 second.2 Turn O to select [4 SIGNALING].3 Press H.4 Turn O to select [11 SQL TYPE].5 Press H.6 Turn O to select [TONE SQL].7 Press M.8 Turn O to select [12 TONE SQL FREQ].9 Press H.10 Receive the signal from the remote station.11 Press and hold B over 1 second.[TONE SEARCH] appears.12 Release B.Search for the tone frequency starts.When a corresponding tone frequency is detected, a beepis emitted and search stops temporarily. The detected tonefrequency blinks.Tip To set the searched tone frequency and exit from the Set mode:Press B a beep is emitted. Quickly press M 3 times.TipFor the operation to perform when scan stops, refer to “Selecting a Reception Method When ScanningStops” on page 59.Selecting a DCS CodeYou can select a DCS code from among 104 DCS codes (023 to 754).1 Specify the operating frequency.2 Press and hold M over 1 second to enter the Set mode.3 Turn O to select [4 SIGNALING].4 Press H.5 Turn O to select [2 DCS CODE].6 Press H.