88Communicating with a Specific Remote StationUsing the Tone Squelch FunctionNotification of Call from the Remote Station byVibration of the VibratorSet the vibrator to alert you of a call from a remote station containing a correspondingCTCSS tone or DCS code.Enter the Set mode:1 Press and hold M over 1 second.2 Turn O to select [8 CONFIG].3 Press H.4 Turn O to select [22 VIBRATOR].5 Press H.6 Turn O to select [MODE].7 Press H.8 Turn O to select [SIGNALING].9 Press p to set the Vibrator mode and exit the Set mode.Tip To turn off the Vibrator function, select [OFF] in step 7.Tips• The vibrator function can be set for all frequency bands belonging to A-band (Main) and B-band(Sub).• Selecting [8 CONFIG] [22 VIBRATOR] [MODE] andthen [BUSY] for [MODE] in the Set mode will cause the vibrator tostart vibrating when the BUSY LED lights upon reception of asignal.• If the BUSY state is not held continuously over 5 seconds, thesuspended state is canceled.If the p switch is operated to change the communication mode from transmission to receptionwhen the vibrator is turned ON, the vibrator function is turned off for 5 seconds.Selecting Vibrator Operation ModeEnter the Set mode:1 Press and hold M over 1 second.2 Turn O to select [8 CONFIG].3 Press H.4 Turn O to select [22 VIBRATOR].5 Press H.