89Communicating with a Specific Remote StationUsing the Tone Squelch Function6 Turn O to select [SELECT].7 Press H.8 Turn O to select a vibrator operation mode.Remark Default: MODE1MODE1 The vibrator vibrates continuously.MODE2 The vibrator operates at long intervals.MODE3 The vibrator operates at short intervals.9 Press p.Sets the Vibrator mode and exits from the Set mode.Notification of a Call from a Remote Station by the BellSet the Bell sound and the blinking b icon on the LCD, to alert you of a call from aremote station containing a corresponding CTCSS tone or DCS code.Enter the Set mode:1 Press and hold M over 1 second.2 Turn O to select [4 SIGNALING].3 Press H.4 Turn O to select [1 BELL].5 Press H.6 Turn O to select [SELECT].7 Press H.8 Turn O to select [BELL].When the tone squelch or DCS function is turned on, theb icon appears.9 Press p to set the bell function and exit Set mode.Tip To turn off the bell function, select [OFF] in step 6.Tips• To use the bell function, turn on the tone squelch or DCSfunction.• The bell function cannot be used via the repeater.• The b icon appears when the bell function is turned on.Upon receipt of a signal from a remote station, the b icon blinks.Changing the Number of Times the Bell RingsEnter the Set mode:1 Press and hold M over 1 second.2 Turn O to select [4 SIGNALING].3 Press H.䎔 䎃䎔 䎃 䎃 䎥 䎨 䎯 䎯䎥 䎨 䎯 䎯䎃 䎃 䎶 䎨 䎯 䎨 䎦 䎷 䎃 䎃䎶 䎨 䎯 䎨 䎦 䎷 䎃 䎃 䎃䎝 䎃 䎃 䎥 䎨 䎯 䎯䎝 䎃 䎃 䎥 䎨 䎯 䎯䎃 䎃䎵 䎬 䎱䎪 䎨 䎵 䎃 䎝 䎃 䎃 䎔 䎃 䎃 䏗 䏌 䏐 䏈