60Scanning FunctionUsing the Scanning FunctionTips • Turn O clockwise.: Scanning is performed toward higher memory channel numbers.Turn O counterclockwise: Scanning is performed toward lower memory channel numbers.• When a signal is received during scanning, scanning stops for 5 seconds and this frequencyis received.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To stop scanning, press p.Tips• Even during scanning, you can adjust the squelch in the following procedure:Press F Press T. Turn O to adjust the squelch.• During scanning, you can finish the squelch adjustment in the following procedure:Press F Press T.• When a memory channel is recalled, the regular memory channels (memory channel numbers1-900) are scanned.• When a memory bank is recalled, only the memory channels in the memory bank are scanned.• For the operation to perform when scanning stops, see [Selecting a Reception Method WhenScanning Stops] on page 59.• Press and hold M over 1 second to select the Set mode option, and then select the followingsetting items for more convenient use:[8 CONFIG] [3 BEEP] [EDGE]: Emits a beep when the frequency band edge is reached.[8 CONFIG] [3 BEEP] [SELECT]: Prevents a beep from being emitted when scanning stops.[5 SCAN] [2 SCAN LAMP]: Prevents the LCD from being lit when scanning stops.[5 SCAN WIDTH] [5 SCAN]: Range for scanning can be selected.Specifying a Skip/Selected Memory ChannelYou can specify two types of memory channels, a skip memory channel and a selectedmemory channel, for effective memory channel scanning.Skip memory channel: You can specify a memory channel that need not be scannedduring memory channel scanning.Selected memory channel: You can specify selected memory channels so that onlythe specific memory channels are scanned during memoryscanning.1 Switch to the Memory mode, and then recall the memorychannel you want to specify as a skip memory channel or aselected memory channel.2 Press and hold M over 1 second.Enters the Set mode.3 Turn O to select [3 MEMORY].4 Press H.5 Turn O to select [5 MEMORY SKIP].6 Press H.7 Turn O to select [OFF], [SKIP], or [SELECT].8 Press p to save the setting and exit from the Set mode.
