59Scanning FunctionUsing the Scanning FunctionSelecting a Reception Method When Scanning StopsWhen scanning stops, you can select one of the following three reception methods:(1) The signal is received for the specified period of time, and then scanning resumes.You can specify this period of time in steps of 0.5 second within the range from 2 to10 seconds.(2) The signal is received until it fades out. Two seconds after the signal fades out,scanning resumes. [BUSY] appears on the LCD.(3) Scanning stops and the current frequency is received. [HOLD] appears on the LCD.1 Press and hold M for over 1 second.2 Turn O to select [5 SCAN].3 Press H.4 Turn O to select [4 SCAN RESUME].5 Press H.6 Press H again.7 Turn O to specify the reception method.Select a reception method from [2 SEC TO 10 SEC (0.5SEC STEP)], [BUSY], and [HOLD].8 Press p to save the specified reception method and exitfrom the Set mode.Tips• The reception method selected here is also applied to [VFO Scanning], [Programmable MemoryChannel Scanning] and [Memory Channel Scanning].• The scanning restart time after BUSY (duration of signal reception) can be changed by selecting theSet mode option [5 SCAN RESTART] [3 SCAN RE-START].Memory Channel ScanningFrequencies registered to the memory channels can be scanned in the order of memorychannel number.1 Switch to the Memory mode and recall a memory channel.2 Press F and then 2.Scanning (SCAN) is performed toward higher memorychannel numbers.When a signal is received, the decimal point blinks.䎗 䎃 䎶 䎦 䎤 䎱 䎃䎶 䎦 䎤 䎱 䎃 䎃䎵 䎨 䎶 䎸 䎰 䎨䎵 䎨 䎶 䎸 䎰 䎨䎃 䎃 䎃 䎶 䎦 䎤 䎱 䎃䎦 䎤 䎱 䎃 䎃 䎝 䎃 䎘 䎑 䎓 䏖 䏈 䏆䎃 䎃 䎃䎧 䎺 䎃 䎃 䎃 䎃䎧 䎺 䎃 䎃 䎃 䎃 䎃 䎝 䎃 䎃 䎫 䎲 䎯 䎧 䎃 䎃䎝 䎃 䎃 䎫 䎲 䎯 䎧 䎃 䎃 䎃 䎃䎃䋱䋶䋰When a signal is received,the decimal point blinks.