44Using the MemoryA Wide Variety of Memory FunctionsSplit MemoryTwo different frequencies, one for reception and other for transmission, can beregistered to a memory channel.1 Register a receive frequency to a memory channel.Remark See “Registering to Memory Channel” above.2 Select a transmit frequency in the VFO mode.3 Press and hold F over 1 second.4 Turn O to select the memory channel number that you registered the receivefrequency to.5 While pressing p, press F to save the Split memorychannel.When you recall the memory channel to which youregistered two different frequencies (one for receive andthe other for transmit), the @ appears on the LCDRecalling a Memory ChannelRecall a registered memory channel using the following procedure:1 Press V to enter the Memory mode and the memorychannel you used last appears on the LCD.2 Turn O to select the desired memory channel.Select the memory channel to use.Remarks • You can directly recall a memory channel using numerickeys.To recall memory channel 15: Press 15H• Pressing F and turning O allows you to skip memory channels quickly in steps of 10memory channels.3 Press V to exit the Memory mode, and the frequency selected in the VFO modeappears.Tips• Unregistered memory channels are skipped.• By default, a priority memory channel, which is used as dual receive priority memory channel, isset to the memory channel number 1. [P] appears on the upper right corner of the priority memorychannel number (See page 75).• The frequency registered to a memory channel can be transferred to the VFO operating band in thefollowing procedure:Press and hold F over 1 second. Press V “OVERWRITE OK?” appears Press V.• To place the FT1DR/DE transceiver in the Memory Channel only mode, use the following procedure,which allows the use of memory channels only.Press V while pressing P to turn on the transceiver.To cancel the Memory Channel Only mode, press P while pressing V again.䋴䋳䋰䋮䋰䋰䋰䋴䋳䋰䋮䋰䋰䋰