41Repeater OperationRepeater ShiftThe FT1DR/DE has been configured, at the factory, for the repeater shifts customary inthe country where it is sold. For the 144 MHz band, this usually will be 600 kHz, whilethe 430 MHz shift will be 1.6 MHz, 7.6 MHz, or 5 MHz (USA version).Depending on the part of the band in which you are operating, the repeater shift may beeither downward () or upward (+), and one of these icons will appear to the right of thedisplay frequency on the LCD when repeater shifts have been enabled.Automatic Repeater Shift (ARS)The FT1DR/DE Automatic Repeater Shift feature causes the appropriate repeater shiftto be automatically applied whenever it is tuned into the designated repeater sub-bands.If the ARS feature does not appear to be working, you may have accidentally disabled it.To re-enable ARS:1 Press and hold the M for over 1 second to enter the set mode.2 Turn the O to select [8 CONFIG].3 Press H.4 Turn the O to select [14 RPT ARS].5 Press H.6 Turn the O to select “ON” (to enable Automatic Repeater Shift).7 Press the p to save the new setting and exit the Set mode.
