40Repeater OperationRepeater OperationRepeater OperationCommunicating Via the RepeaterThe transceiver includes an ARS (Automatic Repeater Shift) function which permitscommunication through the repeater automatically just by setting the receiver to therepeater frequency.1 Set the receive frequency to the repeater frequency.“ ” or “ ” appears in the upper right corner of theLCD.2 Press p, to begin communicating through therepeater.Tips• Pressing F and then pressing 5 enters the “reverse” state where the transmit frequencyand the receive frequency are temporarily reversed. This allows you to check and find if directcommunication with the remote station is possible.• In the “reverse” state, [ ] blinks on the LCD.• Pressing F again and then 5 exits the “reverse” state.• Press and hold M over 1 second to enter the Set mode and change the options to allow moreconvenient use of this function.[8 CONFIG] [14 RPT ARS] You can deactivate the ARS function.[8 CONFIG] [15 RPT SHIFT] You can set the repeater shift direction.[8 CONFIG] [16 RPT SHIFT FREQ] You can change the repeater shift step.Tone Calling (1750 Hz)If your transceiver is FT1DE (European version), press and hold in the T switch(just below the p switch) to generates a 1750 Hz burst tone to access the Europeanrepeater. The transmitter will automatically be activated, and a 1750 Hz audio tone willbe superimposed on the carrier. Once access to the repeater has been gained, you mayrelease the T switch, and use the p switch for activating the transmitter thereafter.If you need to access the repeaters which requires a 1750 Hz burst tone for access bythe FT1DR (USA/EXP versions), you can set the T switch to serve as a “Tone Call”switch instead. To change the configuration of this switch, use Set Mode [8 CONFIG] [10 MONI/T-CALL].䰀䰀䎚 䯺䎕䎘䎕䎘 䯼䯽䰀 䎙䯺䯽䯼䯼