64Scanning FunctionUsing the Scanning FunctionPerforming Programmable Memory Channel ScanThe programmable memory channel scan allows you to scan a specified frequencyrange within the same frequency band.1 Switch to the Memory mode.Recall a PMS memory channel to which the lower limitfrequency or upper limit frequency is registered.2 Press F and then 2.Programmable memory channel scanning starts.Tips • Turn O clockwise: Scanning is performed toward higherfrequencies.Turn O counterclockwise: Scanning is performed towardlower frequencies.• When a signal is received during scanning, scanning stops for5 seconds and this frequency is received.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To stop scanning, press p.Tips• When a skip memory channel is specified for [L] or [U] or when the lower/upper limit frequencyis not properly specified, program memory channel scanning is not performed properly.• Press and hold M over 1 second to select the Set mode option and then select the followingsetting items for more convenient use:[8 CONFIG] [3 BEEP] [EDGE]: Emits a beep when the frequency band edge is reached.[5 SCAN] [2 SCAN LAMP]: Prevents the LCD from being lit when scanning stops.• Even during scanning, you can adjust the squelch in the following procedure:Press F Press T Turn O to adjust the squelch.• During scanning, you can finish the squelch adjustment in the following procedure:Press F Press T.Decimal point blinks.
