77Convenient FunctionsDual Reception (DW) FunctionCautionBe sure to set a memory channel as the Priority Memory Channel for standby before using thisfunction.Tips• The Priority Memory Channel is set to the Memory Channel number 1 by default.• Pressing and holding M over 1 second and changing the Set mode option allows you to use thisfunction more conveniently.[5 SCAN] [1 DW TIME]: The interval for monitoring the Priority Memory Channel can be changed.[5 SCAN] [4 SCAN RESUME]: The resumption conditions for Dual Reception can be changed.• The combination of the frequency bands and modes of the frequency for the Priority MemoryChannel (standby side) and the frequency for continual signal reception (active side) can be freelychanged.AF-DUAL Function for simultaneous signal reception over theother frequency while listening to the radioThe AF-DUAL Reception Function allows reception of a radio broadcast, while standbyreception of A-band or B-band frequency (or frequency registered to a memory channel)is active. When standby reception is active, voice received over that frequency cannotbe heard, however if a voice signal is detected, the reception of the radio broadcast willbe paused and voice will be heard. Although there is a similar function in Dual Reception(See page 76), because a signal reception over the frequency registered to the prioritymemory channel is checked approximately every 5 seconds in Dual Reception, thereception for radio broadcast is interrupted every time this happens. With the AF-DUALReception Function, the reception of radio broadcast is interrupted only when there is acalling signal from another transceiver. Listening Radio Broadcast with AF-DUAL Reception Function1 Set the A-band or B-band frequency (or Memory Channel/Home Channel) forstandby. Set the standby reception frequency for A-band or B-band (or MemoryChannel/ Home Channel) to monitor for calls while receiving radio broadcast.Tips • You can listen to radio broadcast while scanning the standby signal reception frequencies.• Radio broadcast can be listened to while monitoring the standby signal reception frequencyin the dual reception mode.2 Press A to set the operating band to A-band.3 Press F and then 6 to activate the AF-Dual function.4 Press B and select [AM] or [WFM].The broadcast band is toggled in the following order everytime B is pressed:AM broadcast (middle wave band) ⇔ FM broadcast ⇔ AMbroadcast (middle wave band)On the LCD, AM (AM broadcast) or WFM (FM broadcast)is displayed.5 Turn O to tune in to the frequency of broadcast station.