125Functions Used As NeededSet Mode12 Turn O to select the range for scanning.Mode Display* Operation StatusVFO ModeALL Scans all bands within the range from the current frequency to 108-999MHz.BAND Scans the current band (see the table on the next page) starting with thecurrent frequency.MemoryModeALL CHScans all memory channels (1-900) of the currently selected memorychannel. When selected memory channels are specified, all of them arescanned (See page 59).BANDScans only the memory channels to which frequencies in the samefrequency band* 1 are registered. When the selected memory channelsare specified, scans only the selected memory channels to whichfrequencies in the same frequency band *1 are registered (See page 61).*1 For the relationship between frequency bands and reception frequencies, see the table at thebottom of page 28.13 Press p to save the range for scanning, and exit the Set mode.Turning off the power automaticallyAPO FunctionThe transceiver may be set to turn off automatically if there is no operation for a certainperiod of time.Enter the Set mode:1 Press and hold M for over 1 second.2 Turn O to select [8 CONFIG].3 Press H.4 Turn O to select [1 APO].5 Press H.6 Turn O to set the time.Set the time for the transceiver to turn off automatically insteps of 30 minutes.OFF/30 MIN/1 HOUR to 12 HOURSRemark Default: OFF7 Press p to save the auto power-off function setting, andexit the Set mode. The transceiver will be automaticallyturned off if there is no operation for the set period of time.