87Communicating with a Specific Remote StationUsing the Tone Squelch Function7 Turn O to select a DCS code.8 Quickly press M 3 times to set the DCS code and exitfrom the Set mode.TipBy default, the DCS code is set to [023].Searching for the Frequency of the DCS Used by the Remote StationThe DCS code used by the remote station can be searched for and displayed.Enter the Set mode:1 Press and hold M over 1 second.2 Turn O to select [4 SIGNALING].3 Press H.4 Turn O to select [11 SQL TYPE].5 Press H.6 Turn O to select [DCS].Sets the DCS.7 Press M.8 Turn O to select [2 DCS CODE].9 Press H.10 Receive the signal from the remote station.11 Press and hold B over 1 second.[DCS SEARCH] appears.12 Release B.Searching for the DCS code begins. When a correspondingDCS code is heard, a beep is emitted and search stopstemporarily. The found DCS code blinks.Tip To set the searched DCS code:Press B a beep is emitted. Quickly press M 3 timesto set the DCS code and exit from the Set mode.TipTo perform the operation when scan stops, refer to “Selecting a Reception Method When ScanningStops” on page 59.
