Azbil MagneW FLEX+/PLUS+ MGG10C manuals
MagneW FLEX+/PLUS+ MGG10C
Table of contents
- about this manual
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Main components
- Figure 1-2 Remote System
- Analog output and digital output
- System configuration WITHOUT the communication function
- System configuration WITH the HART communication function with the internal power supply
- System configuration WITH the SFC or HART communication function with the external power supply
- System Configuration for Digital Output (DE Output)
- Figure 1-7 Parts of the converter
- Approval of this Device
- Figure 1-8 System configuration
- Site selection
- Unpacking and storage
- Installation options
- Changing the orientation of the converter
- Wiring
- Integral wiring - 1 (1-contact input and 1- contact output)
- Integral wiring - 2 (2-contact input)
- Integral wiring - 3 (2-contact output)
- Remote wiring - 1 (1-contact input and 1- contact output)
- Remote wiring - 2 (2-contact input)
- Remote wiring - 3 (2-contact output)
- Grounding
- Figure 2-11 Signal Cable Dimensions
- Signal and excitation cable wiring
- Wiring cable
- Figure 2-16 Wiring diagram for pulse output
- Figure 2-18 Wiring diagram for contact input
- Setting write protection
- Figure 2-20 Switch locations on main card
- Setting the communication via the HART
- Setting the empty detection function
- Setting the communication via the SFC
- Connecting power
- Start-up
- Using the display panel
- Using the infrared touch sensor keys
- Table 3-1 Touch Sensor key Functions
- Table 3-2 Default settings
- About modes
- Table 4-1 Mode functions
- MEASURING MODE
- LCD display flow
- Entering BASIC SETUP MODE
- Default setting
- Damping time constant
- Auto zero
- Flow counter - Reset value
- Flow counter - Resetting
- Detector data
- Setting the Number of Dummy Detectors
- Flow rate range
- Flow rate indication
- Entering ENGINEERING / ADVANCED / MAINTENANCE MODE
- Entering MAINTENANCE MODE
- Selecting functions
- Relations for setting function FXXXX
- Range functions
- Normal direction automatic dual range
- Normal direction, external switching dual range
- Normal/reverse automatic switching range
- Built-in counter function]
- Contact input function]
- Contact output function]
- Figure 4-4 2-stage flow rate alarm output
- Setting hysteresis
- Selecting the current output method for dual range
- Setting / Changing the preset value of the built-in flow counter
- Specific gravity
- Pulse weight
- Setting the pulse width
- Setting high and low limit alarms
- Setting a 2-stage flow rate alarm
- Selecting fail-safe mode for the analog output
- Selecting fail-safe mode for the pulse output
- Setting the contact output status
- Manual zeroing
- Setting moving average
- Auto spike cut function
- Manual spike cut function
- Coefficient of compensation
- Setting the drop-out
- Setting the low flow cut
- Setting decimal place
- Change the excitation frequency
- Setting the analog output limit
- Change the flow direction
- Error history check/clear
- troubleshooting
- Function check
- Analog output check
- Pulse output check
- Contact input/output loop check
- maintenance and troubleshooting
- Excitation current check
- Simulated signal by the calibrator
- Troubleshooting
- Errors at startup
- Operation errors
- Error messages
- Error codes for non-critical problems
- Safety precautions
- Structure and functions of SFC
manualsdatabase
Your AI-powered manual search engine