Installation Azbil Corporation2-8 Model MGG10C/14C - MagneW FLEX+/PLUS+ ConverterIntegral wiring - 3 (2-contact output)To wire a remote system, the following cables are required:• Analog output cable - see page 2-16• Pulse output cable - see page 2-17• Contact input/output cable - see page 2-17The following pages provide information on selecting the correct cables and wiringthe system. A diagram of the terminal block for a remote system is shown below.2-contact outputACPOWERE STATUS OUT 2 STATUS OUT 1+ - + -+ - + -POWER ACL N I. OUTP. OUTE STATUS OUT 2 STATUS OUT 1+ - + -+ - + -POWER ACL N I. OUTP. OUTSB SA C ABX YSB SA C ABX YFigure 2-6 Integral converter terminal blockTable 2-3 Remote converter terminal descriptions (2-contact output)Symbol DescriptionI. OUT + Analog output–P. OUT + Pulse output–STATUS OUT 1 + Contact output 1–STATUS OUT 2 + Contact output 2–E Not usedGrounding (grounding resistance must be <100 W)~ Note In case of DC24V and DC110V power supply, the symbol of the “L” and “N” of thepower supply become “+” and “–”.
