Azbil Corporation Using the display panelModel MGG10C/14C - MagneW FLEX+/PLUS+ Converter 4-23Entering ENGINEERING / ADVANCED / MAINTENANCE MODEThis is to describe how to enter ENGINEERING, ADVANCED andMAINTENANCE MODE.~ CAUTION Check the write protection level to enter each mode (See page 2-19).Entering ENGINEERING MODEStep Screen Procedure(English) (Japanese)1 MODE ENTERENGINEERINGEnter BASIC SETUP MODE(see page 4-11). Use theor key to cycle through thescreens until the MODE ENTERENGINEERING screen appears.2 MODE ENTERENGINEERINGTouch the key once to movethe cursor to ENGINEERING.3 ENGINEERINGMODETouch the key to select. TheENGINEERING MODE screenappears.4 FUNC SET FQAXX Two seconds later, Function setscreen appears.Entering ADVANCED MODEStep Screen Procedure(English) (Japanese)1 MODE ENTERADVANCEDEnter BASIC SETUP MODE(see page 4-11). Use theor key to cycle through thescreens until the MODE ENTERADVANCED screen appears.2 MODE ENTERADVANCEDTouch the key once to movethe cursor to ADVANCED.
