Using the display panel Azbil Corporation4-60 Model MGG10C/14C - MagneW FLEX+/PLUS+ ConverterAuto spike cut functionThis function eliminates steep noise spikes (spike noise) in the flow rate. Noisegenerated when solids hit the electrode is an example of the spike noise.When the flow rate changes sharply, this function holds the outputs according to thedamping time. Generally the spike noise occurs in a few milliseconds and settlesdown within the output holding time and the outputs are not affected. For ordinaryflow rate changes, the output responds after the damping hold time.It is not recommended to use this function for applications requiring high responseand performance, e.g., the function should not be used when a pump frequentlygenerates pulsation.Default settingOFFStep Screen Procedure(English) (Japanese)1 AUTO SPIKE CUTOFF&OFF&Enter the ADVANCED Mode.(See page 4-23). Use theor key to cycle through thescreens until AUTO SPIKECUTscreen appears.2 AUTO SPIKE CUTOFF&OFF& Touch the key to move thecursor to the OFF.3 AUTO SPIKE CUTAUTO&AUTO&Touch the key to switchthe OFF screen to the AUTOscreen.4 AUTO SPIKE CUTAUTO&AUTO& Touch the key to move thecursor to back to “&”.5Touch the MODE key to returnto the MEASURING MODEand save the data.
