CHAPTER 1 - SYSTEM OPERATIONLSM 880 Left Tool Area and Hardware Control Tools ZEISS10/2014 V_01 000000-2071-464 2495.3.13 Action Buttons for FCSThe Action buttons are used to triggermeasurements and to adjust the measurementconditions. The following buttons are available(Fig. 333):− New: opens up a new Image FCS Diagramwithin a container.− Count rate: opens the Count rate window.− xyz-Scan: triggers a one dimensional (x, y, z)or two dimensional (xy, xz, yz) scan.− Snap: Starts a single measurement at the first (Sample Carrier) or highlighted (LSM Image) position.− Start Experiment: Starts sequential measurements on all marked or highlighted positions.− Stop: Ends or interrupts the current measurement (Appears only when a measurement is activelyrunning and replaces than the Start Experiment and the Snap buttons simultaneously.Scans and measurements are performed according to the settings and methods defined in the FCStools.Above and below the Action buttons the Method tool and Activation tab areas are available.Besides the action button the Method tool allows to save, load and delete methods. The active tab areaallows some of the tabs to be activated by checking the corresponding boxes.Fig. 333 Action buttons
