CHAPTER 1 - SYSTEM OPERATIONLSM 880 Center Screen Area / Image Containers - Display and Image Analysis ZEISS10/2014 V_01 000000-2071-464 4636.9.9 SeriesThe Series tab (Fig. 654) displays the RenderSeries control panel. This panel allows settings forthe axis to be used for rotation of the 3Dreconstructed images. This feature is applicable toall render modes available in 3D VisArt.There are four different modes for producingrender series (see Fig. 656).Depending on the activated mode, directly set theparameters for animation in the Render Serieswindow and the position of the 3D image in theImage Display window (zoom, rotation axes,rendering parameters).Click on Apply to start the animationThe animation is performed in a separate ImageDisplay window, which permits the animation tobe saved afterwards.(1) Turn around X and Turn around Y modeIn this mode, the image is turned around the X-axis or the Y-axis exclusively.The values for Number of Views, Difference Angle and First Angle can be selected accordingly).(2) Start and End modeIn the Start and End mode, the image is recon-structed between a start position and an endposition.The rotation angles for X, Y and Z and the distance(zoom) can be determined using the sliders.The value for Total frames can be varied. Theframes are distributed equally between the startand end points (Fig. 657).Fig. 654 Series tabFig. 655 Render Series window(e.g. Turn around X mode)Fig. 656 Render Series modesFig. 657 Start panel in the Render Viewcontrol block
